Smart Up SeriesUninterruptible Power SupplyUser’s Manual
OFF SWITCHPress and release this switch to turn the UPS OFF. The UPS will continue to charge thebatteries whenever it is plugged in and the utility li
If an overload occurs, the OVERLOAD LED will light and an uninterrupted alarm will beheard. Under this condition, check the load connected to the UPS.
OVER TEMPERATUREWhen temperature inside the UPS is too high, the LED of Buck, Boost, Normal and OnBattery will light, the alarm will sound continuousl
TROUBLESHOOTING CHARTProblemNo alarm, No LEDindication (UPS is notturned on).UPS does not provideexpected back-up timeAll LEDs are on.‘REPLACE BATTERY
REPLACING THE BATTERYThe Smart Up Series UPS has easy-to-replace hot-swappable batteries. Pleaseread the following warning statements before attemptin
BATTERY REPLACEMENT PROCEDUREPLEASE READ THE PREVIOUS “CAUTIONS” SECTION BEFORE ATTEMPTINGTO REPLACE THE BATTERIESBattery replacement is a safe proced
5. Disconnect the battery:For 700VA and 1000VA models, disconnect the batteries and UPS byloosening the connectors.For 1400VA model, disconnect the ba
IF THE UPS REQUIRES SERVICE1. Use the TROUBLESHOOTING Section 5 to eliminate obvious causes.2. Verify that no circuit breakers are tripped. A tripped
NOTE: 230VAC Specs Shown In ( )Acceptable input VoltageInput Voltage (on-line operation)Output Voltage (on-line operation)Nominal input frequencyInput
LIMITED PRODUCT WARRANTYPara Systems Inc. (Para Systems) warrants this equipment, when properly applied andoperated within specified conditions, again
Notes:18
Notes:19
Para Systems, Inc.1455 LeMay Dr.Carrollton, TX 75007Phone: (972) 446-7363Fax: (972) 446-9011QuickFax Info System: 1-800-263-3933Internet: www.minutema
Smart Up Series User’s Manual1. Introduction 22. Controls and Indicators 43. Installation 64. Operation 75. Troubleshooting 116. Replacing the Battery
Thank you for purchasing a Minuteman power protection product. It has been designedand manufactured to provide many years of trouble free service.Plea
Receiving InspectionAfter removing your Minuteman UPS from its carton, it should be inspected for damage thatmay have occurred in shipping. Immediatel
FRONT PANELPress and release the On/Test/Alarm Silence button to turn on, test or silencethe alarm.Press and release the OFF button to turn the UPS OF
Minuteman Smart UpRear PanelSite Wiring FaultDB9ConnectorAccessory SlotOption SlotOutput ReceptaclesInput CircuitBreakerSurge Only ReceptacleInput Pow
REAR PANELThe Accessory Slot is used for SNMP UPS monitoring. Available from Minuteman.The DB9 connector is used for UPS monitoring and control throug
SITE WIRING FAULTAfter plugging in the UPS, check the site wiring fault (SWF) LED on the rear of the unit. If theLED is illuminated, the UPS is plugge
Comments to this Manuals