2
OPERAOPERA
OPERAOPERA
OPERA
TING INSTRUCTIONSTING INSTRUCTIONS
TING INSTRUCTIONSTING INSTRUCTIONS
TING INSTRUCTIONS
INSPECTIONINSPECTION
INSPECTIONINSPECTION
INSPECTION
Carefully unpack and inspect your burnisher for shipping damage. Each unit is tested and thoroughly
inspected before shipment; any damage is the responsibility of the delivery carrier who should be
notified immediately.
ELECTRICALELECTRICAL
ELECTRICALELECTRICAL
ELECTRICAL
This machine is battery operated and designed to operate on 36 volts DC (3) 12 volt batteries.
BABA
BABA
BA
TTERIESTTERIES
TTERIESTTERIES
TTERIES
Burnishers are shipped with batteries. (3 required)
Part No. 956210 12V 210AH 20 Hr. Rate (Optional)
We do not recommend mixing AMP hour capacities. Any alternate battery sets can be used if
they equal physical size and capacity. See next page for service and installation.
OPERAOPERA
OPERAOPERA
OPERA
TIONTION
TIONTION
TION
Before starting, familiarize yourself with the machine and its controls (see “Machine Overview” and
“Control Panel” diagrams). To turn the machine ON, do the following:
1. Make sure 20” high speed pad is used. Make sure the pad is installed on the machine by
following instructions under”Pad Installation.”
2. Make sure that no battery charger is plugged into the recharge port.
3. Lift the red emergency disconnect button so it is in the up position.
4. Lower the pad driver assembly by pushing the pedal slightly outward on the machine (unlock it),
and then release it slowly.
5. Turn the power switch to the ON position. The pad driver will then slowly adjust itself to the floor.
Move forward in a straight line, check the reading on the Operating Range Meter and make
sure you are in the Green Zone.
6. Place hands on the bails and squeeze the bail levers to start the operation of the machine.
Move forward in a straight line, check the reading on the Operating Range Meter and make
sure you are in the Green Zone.
7. Adjust the pad pressure as needed by turning the knob accordingly. (See Pad Pressure
Adjustments.)
8. Adjust speed as needed by turning the speed control knob accordingly.
AFTER USEAFTER USE
AFTER USEAFTER USE
AFTER USE
To raise the pad driver, push down until the pedal arm engages into the pedal catch. Turn machine
off by turning the key switch on the control panel. Machine can be cleaned with a mild detergent and
a damp cloth. Batteries should be charged after each use or when the battery condition meter
shows a low charge. Once the battery charger reads 0 amps, the batteries are recharged. This
should take approximately 8 hours if the batteries are completely discharged.
MAINTENANCEMAINTENANCE
MAINTENANCEMAINTENANCE
MAINTENANCE
Periodically remove batteries from machine. Clean the batteries and battery tray with a solution of
baking soda and water. Check all battery cables and wiring for signs of damage and wear. Replace
as needed. Grease front wheel and rear caster zerks once a month for best operation.
FLOOR SEAL STRIPFLOOR SEAL STRIP
FLOOR SEAL STRIPFLOOR SEAL STRIP
FLOOR SEAL STRIP
When the floor seal strip show signs of excessive wear, seal should be replaced. The strip can be
removes by loosening the screw on the retainer strap until the seal can slide off of the pad shroud
housing. To install new seal, slip the retainer strap over the new seal strip and pad shroud. Make sure
the seal is seated equally around the perimeter and the holes on the floor seal are oriented towards
the back portion of the shroud.
(23 pages)
(20 pages)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comments to this Manuals